The RoboRocker 3X2 has 6 well plate docks in a 3 x 2 array. The platform can hold more than 6 plates, if the plates are stacked. The dock guides can be removed to allow the platform to hold items that are not shaped as well plates. The platform can be rotated so that the well plates tilt along their length or along their width. Programmable tilt platform designed for microfluidic organoid and 3D cell culture. Touch screen user interface. Programmable cycle to run and pause at up to 4 tilt positions Each tilt position can be up to ±30° Travel rate programmable from 5 degrees per second (0.2 seconds per degree) to incredibly slowly at 5 hours per degree Pause, programmable, at each position from 0 seconds (no pause) to 24 hours Can maintain near constant flow rate in microfluidic channels using very slow travel rate to compensate for decreasing height difference between reservoirs Platform sizes (the well plate docks or guides can be removed so the platforms can hold other labware): 8 x 11 inches (20 x 28 cm). 4 well plate docks in a 2 x 2 array. 11.5 x 11.5 (29 x 29 cm). 6 well plate docks in a 3 x 2 array. Well plates can be stacked. E.g. a 6 dock platform can hold 24 well plates (or culture cartridges, if they are stacked 4 high Platform can be rotated, so that your culture cartridges tilt along their length or along their width. Stacking trays are available to double the capacity Color touch screen user interface Platforms have a textured rubber mat. The mat can be removed. Can use in cold rooms and incubators, 4°C to 40°C (avoid condensation) Resistant to CO2 environments up to 10%. CE certified 24 volt power supply – works with wall outlets worldwide 1 year warranty 30 day money back guarantee Made in the USA