Checkit Go 10 uL The Checkit Go enables you to easily measure the volumes dispensed by a robot or multi-channel pipette, in under 10 seconds. Just place the dye in the reservoir on the cartridge, and place the well-plate-size cartridge on the robot (or where you are using the multi-channel pipette. Dispense the dye into the 8 wells, flip the tab, and read the level of the dye. It’s that easy! Checkit Go disposable cartridge instantly checks accuracy of liquid handlers and multi-channel pipettes The Checkit Go is an easy-to-use, stand-alone, disposable cartridge that allows you to check the accuracy of your liquid handling robot or multi-channel pipette in just seconds. No additional equipment is required. The Checkit Go is interchangeable with well plates, so it works with all robots that handle 96 well plates. Compatible with all makes of multi-channel or electronic pipettes. Fast and Convenient – verify up to 8 channels in seconds This surprisingly simple device measures the dispensed volumes of up to 8 channels simultaneously. It is the size of a well plate, so you can use it in your robot, or on a lab bench, or anywhere. You’re done in under 10 seconds. That means no more trying to read a tiny droplet’s weight on a high-precision balance, and repeat for 7 more channels. Accurate – directly measures liquid volume of your samples The Checkit Go directly measures the volume of the liquid dispensed, not an indirect measurement of the weight or the color change of a liquid. In addition to being so quick and easy to use, the Checkit Go limits evaporation to negligible levels because the dispensed droplets are mostly encased in glass tubes within seconds. Measurements are guaranteed to be accurate to within 2% and typically better than 1%. The Checkits can measure dispensed volumes of a spectrum of aqueous samples, including 10% solutions of DMSO, glycerol and ethanol, and other aqueous samples such as serum and plasma. This eliminates sources of error due to differences in viscosity or surface tension between your samples and concentrated dye or distilled water. Just reconstitute your test liquid in our red dye pellet. Why spend $30K on equipment that could introduce errors? Easy to Use – no training required Just aspirate the dye that is included. Dispense the dye into the wells on the flip tab of the cartridge. Flip the tab. Or let the robot flip the tab. Then watch the dye travel up the 8 channels, simultaneously. Don’t blink or you’ll miss the fun. And compare the level of the dye against the graduations. It’s that easy! No more trying to read a tiny droplet’s weight on a high-precision balance. No training required. No need to learn to use expensive colorimetric systems. And you can record the measurement with a simple photo. Cost-effective – no capital investment The Checkit Go is a fraction of the cost of unnecessary calibration or experiments gone bad due to pipetting errors. It is a low cost disposable cartridge that works on its own. It shows the measured volume directly on the cartridge. Just compare the level of dye against the graduations, without any expensive balances or spectrophotometric equipment.